Rittal DK 7010030 Power Unit, 2 Switched C13 Outputs

Rittal DK 7010030 Power Unit switches and monitors connected equipment in enclosure monitoring systems. Two relay-controlled C13 outputs support individual monitoring and switching based on measured values. Manual switching is available through the connected CMC III, PDU or IoT user interface.

The unit measures voltage, current, power and energy consumption. Typical connected equipment includes fans and heaters, subject to the permitted electrical load. The installation guide requires a compatible Rittal embedded device running software version 10.2.0 or later.

System Compatibility and Load Selection

Select the Power Unit together with its monitoring controller, cables and connected equipment. The RJ45 sockets are CAN bus connections; use the Rittal system cables specified for this application.

• Controller and software: provide the controller article number and installed software version. Check support for the Power Unit before ordering.
• Connected loads: check each device against the 5 A output limit and the combined 10 A limit. Include starting current when assessing fans or other motor loads.
• Control requirements: identify which output will be switched, the measurement or sensor that will trigger it, and the required switching behavior.
• Installation: allow space for mains and CAN bus connectors, cable routing and service access. Installation and mains wiring must be carried out by qualified personnel in accordance with the manufacturer instructions.

Approvals

Downloads

FAQ

Q1: What controller is required for the Power Unit?
A: The installation guide specifies use with a Rittal embedded device running software version 10.2.0 or later. Send the exact controller model and software version so compatibility can be checked.

Q2: Can the outputs switch enclosure fans automatically?
A: Rittal identifies fan control as an application. Automatic switching depends on the connected monitoring system and its configuration. Check the fan operating current, starting current and any required accessories before selecting the output.

Q3: Is each C13 output rated for 10 A?
A: The installation guide specifies a maximum of 5 A for each output. The product data sheet gives a combined limit of 10 A for both outputs.

Q4: Which connection cables should I include in the enquiry?
A: Specify the destination country, mains connection, equipment connectors and CAN bus cable lengths. The published product supply includes the unit and surface mounting parts; confirm the required cables as separate order items.