Rittal VX 8800695 EMC Shielding Seal, 40 mm × 8 m

Rittal specifies this seal for VX baying points used with an external baying connector. Check the full enclosure and connector article numbers when adding it to an existing assembly.

• Prepare the contact area: the manufacturer drawing requires the adhesive area to be free of grease.
• Follow the illustrated seal path: position the strip at the baying joint as shown in the Rittal information sheet.
• Allow for the joint overlap: the installation drawing shows an approximate 50–100 mm overlap at the strip joint. Include this allowance when estimating the roll quantity.
• Review the complete assembly: include the baying connection, doors, removable panels and cable entries in the project's EMC review.

Downloads

FAQ

Q1: Is the external baying connector included?
A: The listed supply for VX 8800695 is one 8 m roll of shielding seal. Include the required external baying connector separately in the enquiry.

Q2: How many rolls are needed for a bayed enclosure row?
A: Measure the seal path for each baying joint, then allow for the overlap shown in the manufacturer drawing and installation cutting allowance. Provide the enclosure sizes and joint count for a quantity check.

Q3: Does this seal establish an IP rating or an EMC performance rating for the cabinet?
A: The seal is specified for shielding the baying point. The complete cabinet configuration determines the applicable protection and EMC performance. Use the relevant enclosure documentation and project verification requirements.

Q4: Can it be used with another enclosure series?
A: Rittal lists VX for this article. For another enclosure series, send the enclosure and baying connector article numbers so the appropriate seal can be checked.