Rittal DK 5502115 Cable Finger for VX IT, 6 U

Rittal DK 5502115 is a 6 U cable finger for organizing cables at the 19-inch mounting level of VX IT racks. It clips directly onto the standard profile rail without tools and provides cable routing in 1 U increments.

Use it when planning cable routes beside rack-mounted equipment. Confirm the profile rail type and space for the cable route before ordering.

Check the Cable Route Before Installation

• Identify the profile rail: This version is intended for the VX IT 19-inch standard profile rail. Check the rail article number when adding cable management to an existing rack.
• Choose the mounting position: Rittal permits mounting on the front face or side of the front and rear profile rails. Choose the position around the equipment connections and the planned cable route.
• Check clearance: Allow room for cable bends, connector access and equipment replacement. Check the actual cable bundle against the available space.
• Coordinate with air baffle plates: Rittal supports using these cable fingers with air baffle plates. Check the mounting layout and follow the assembly instructions for the selected arrangement.

For selection support, send SUWI the rack and profile rail article numbers, cable routing height and photos or drawings of the intended mounting position.

Browse SUWI enclosure accessories for related installation and cable management components.

Downloads

FAQ

Q1: Will DK 5502115 fit any 19-inch rack?

A: This version is specified for the VX IT standard profile rail. A 19-inch equipment mounting width alone does not confirm the snap-fit interface. Send the rack and profile rail article numbers or a clear rail photo before ordering for another configuration.

Q2: How should I calculate the quantity required?

A: Plan each cable route by its required vertical coverage and mounting position. Allow for separate routes at the front and rear or on both sides where needed. Each cable finger spans 6 U and the packaging unit is 14 pieces; send your rack layout if you need help preparing the quantity.

Q3: What should I check before adding cable fingers to a populated rack?

A: Check the free space beside the equipment, access to connectors and the cable manufacturer's bend-radius requirements. Provide photos of the existing cable route and any air baffle plates so the intended position can be reviewed.

Q4: How do I request a price and delivery time?

A: Send DK 5502115, the required number of packs, delivery destination and requested delivery date. Include the rack or rail details if you also need a compatibility check. SUWI will confirm pricing and lead time in the quotation.